Nokta Legend Beast Mode Full Sequence
The more I use the Nokta Legend’s Beast mode, the more impressed with it I am. It allows for very high Sensitivity settings—producing amazing depth on small targets. The audio is also very descriptive although it takes some getting used to. This is a great gold hunting mode as it lets you hear the cleanest, non-ferrous targets. These are the smooth, extended high tones. Also, because it derives from Goldfield mode–its good in black sand.
1/ Press the right arrow to go to Goldfield mode.
2/ Press the Frequency button untill beast mode (bE) is displayed under the “M” on screen.
3/ Press the Ground Balance button to begin the first GB sequence. Pump the coil from a height of about two feet off the ground to the ground untill you get a stable reading. Then press the GB button to exit.
4/ Now press the Ground Balance button again to begin the second GB sequence. Press the frequency button to enter into this second process. “2 gB” should appear at the right of the screen. Press pinpoint as you bob the coil to ground balance. Then press the GB button to exit. This second Ground Balance is abseloutley necessary to stablize the machine in beast mode.
5/ Now adjust the Sensitivity to suit your conditions.
6/ You can also make changes to the Iron Reject by going to the Recovery Speed feature and pressing pinpoint. Where you have iron and “mixed” targets (part iron, part non-ferrous–such as bottlecaps), Iron Reject acts to push these targets down into the lower tones.
7/ You also have the option of changing the Audio Gain by going to the Volume control and pressing pinpoint.
For more information on finding Gold, Silver and Relics with the Nokta Legend, check out my book: